During wild fishing in winter and spring, since the target species of fish are mainly small fish such as crucian carp, most fishermen like to use bait to fish. The bait is fast, the operation is very simple and convenient, and the entrance of small fish is more convenient, and the fishing effect is good.

However, during the actual wild fishing process, it is often found that some anglers, especially novices, will encounter the phenomenon that they cannot pull out even if they add a lot of silk drawing fans. This situation often occurs during the fishing process. Sometimes, I would pull it several times and repeatedly before I could barely pull a little bait on the hook. So, adding silk powder, not only would I not be able to pull out the silk in the end, or if there was silk but I couldn’t pull out the beautiful lump. Sometimes the bait became a ball of “gluten”, which not only wasted the bait, but also added a lot of trouble, causing the originally happy fishing to become depressed.

In actual wild fishing, when using bait pull, sometimes it is indeed related to the silk drawing powder, but not all of them are related to the quality of the silk drawing powder.

First of all, the usage of wire drawing powder of different specifications and different bait formulas is different. Many baits even contain a large amount of wire drawing powder, such as Blue Crucian Wuliangsui, etc., and you should first figure it out when starting the bait.

In fact, the so-called silk-pulling powder is nothing more than the kind of gluten powder, also called gluten. When I was a child, I often added flour to water and stirred it constantly and kneaded it in water, which is also called washing the gluten, and then use the washed gluten to stick to the cicada, which is cicada. In fact, the truth is the same. However, merchants divide the brushed powder into different specifications, and different sizes are marked according to the length of the coarse and fine brushed grains, such as the number of mesh.

It can be summarized simply as long and short filaments. The filaments have large particles, and a small amount of them can be added to draw larger bait balls; while the short filaments are smaller, the fibers are short and thin, so if this kind of wire drawing powder is added, it seems that there is little or no wire drawing on the surface, but the bait pulled out is relatively round and in good condition. If it is such wire drawing powder, it is normal that the large bait ball cannot be pulled out when the bait itself does not contain wire drawing powder.

During actual wild fishing, according to the size of the fishing, pay attention to distinguishing the number of mesh drawing powder. The larger the mesh, the smaller the fishing, the smaller the fishing, and the smaller the fishing, the larger the fishing.

In actual wild fishing, if you are a novice or don’t know how to pull the bait, you will repeat simple things and you will naturally master them if you have too many times. The easiest thing is to strictly follow the requirements. Although it is a bit time-consuming and labor-intensive, it will not be randomly matched and the bait will be turned into gluten. There is no question about the state of the bait and the atomization effect.

If you are a beginner, you can use a small number of wire drawing powder. Although the bait ball pulled out is a little larger, it is still easy to pull out a decent bait. If you are an old fisherman, you naturally don’t need more guidance. Use the length and short silk brush powder, that is, use the silk brush powder of different thicknesses and thicknesses reasonably, so that the bait state and atomization effect are better.

Blue crucian carp and Wuliang baits themselves contain silk drawing powder. Generally, small crucian carp, carp, white strips, etc. can be added without or less. When the water is shallow and the fish mouth is light, not only does it not need to be added, but sometimes it is necessary to add some light bran to adjust the state of the bait. In fact, it is to reduce the amount of bait being drawn to avoid the atomization effect. The bait forms like gluten, which affects the palatability of the fish eating bait.

Secondly, the proportion of bait-pulling water is also very important. Generally, the bait is more accurate in opening and pulling the bait according to the required bait water ratio. Although it is a little troublesome to use a measuring cup, it is not easy to cause the bait to be unable to pull out the wire or too much wire drawing to affect the state and the poor atomization of the bait. Sometimes you will find that when you open the bait, after matching the bait water ratio as required, you will find that the bait is very thin. The main reason is that the waking bait is too short. Often, these baits are highly absorbent. Don’t think that the bait is too thin and add silk drawing powder again. This will affect the state of the bait and cause the gluten bait to be unable to pull out the silk.

After starting the bait, let the bait wake up the bait fully for a period of time. Don’t rush to achieve success. Knead it repeatedly to allow the bait to wake up the bait naturally for enough time. Then easily knead the bait into a ball and squeeze out the air inside with your hands.

When fishing for bait, whether the bait can be pulled out or not, whether the bait can be pulled out, another question is that the magnetic properties of the bait plate you choose are also very important. If the magnetic force of the bait plate is insufficient or the range is not large, it is normal that the bait cannot be pulled out.

Finally, there is the problem of the method of pulling the bait. There is a saying in the fishing world that is good, “skin is not pulled”, that is, slowly pull it inward from the outer layer of the bait ball, do not pull it from the middle of the bait ball, gently hold the bait ball with your hands, and gently pull it out from the edge of the bait ball with your other hand.

Also, during the process of pulling the bait, I found that many fishermen were very random and chaotic in pulling the bait. As a result, they could not pull out the wires in the later stage. The reason may be that there were too many chaotic methods of pulling the bait. The wires in the bait ball were broken, so they naturally couldn’t pull out the later stage. The basic method is to “pull the bigger straight, pull the smaller flat, pull the round side”.

Also, when using silk brush powder in one go, please keep it in sealing and preserving it to prevent failure and deterioration. When purchasing silk brush powder, please pay attention to a regular platform to prevent the silk brush from being unable to be pulled out due to quality problems.

In short, there may be many reasons for problems such as not being able to produce silk when pulling bait or being in poor condition, and the most important ones can be summarized as the above points. According to the amount of wire drawing powder of various baits themselves, the bait is required to be opened according to the bait water ratio; consider the depth of water in the fishing area, the water flow is slow and rapid, and the fish mouth is added reasonably; the bait is awakened for sufficient time; when opening the bait, the various baits and wire drawing powder are combined, stir evenly absorb water, and absorb water thoroughly, and do not rub it repeatedly; the bait must be correct. Doing these well can greatly improve the success rate. At the same time, practice and make novice fishermen can practice more.